Showing 1937–1952 of 2574 results
PEE-551A 3 PHASE PROTECTION SYSTEM CONTROL TRAINER
PEE-546A-2
PEE-551A 3 PHASE PROTECTION SYSTEM CONTROL TRAINER
SCOPE OF LEARNING:
Study of 3 Phase Protection System Control Trainer
PEE-553A INDUSTRIAL INSTALLATION TRAINER
PEE-553A
PEE-553A INDUSTRIAL INSTALLATION TRAINER
SCOPE OF LEARNING:
Electrical Engineering: Wiring, construction and protection of circuits, controls
PEE-564B 3 PHASE SQUIRREL CAGE INDUCTION MOTOR COUPLED WITH DC SERIES GENERATOR TRAINER
PEE-564B
PEE-564B 3 PHASE SQUIRREL CAGE INDUCTION MOTOR COUPLED WITH DC SERIES GENERATOR TRAINER
SCOPE OF LEARNING:
Study of 3 Phase SQ Induction Motor Coupled With DC Series Generator
PEE-566B DC SERIES MOTOR COUPLED WITH AC SYNCHRONOUS ALTERNATOR
PEE-566B
PEE-566B DC SERIES MOTOR COUPLED WITH AC SYNCHRONOUS ALTERNATOR
SCOPE OF LEARNING:
Study of DC Series Motor to AC Alternator
PEE-569B DC COMPOUND MOTOR COUPLED WITH AC SYNCHRONOUS ALTERNATOR
PEE-569B
PEE-569B DC COMPOUND MOTOR COUPLED WITH AC SYNCHRONOUS ALTERNATOR
SCOPE OF LEARNING:
Study of DC Compound Motor to AC Alternator
PEE-577B SPEED CONTROL OF 3 PHASE SLIP-RING INDUCTION MOTOR USING VSI FED INVERTER TRAINER
PEE-577B
PEE-577B SPEED CONTROL OF 3 PHASE SLIP-RING INDUCTION MOTOR USING VSI FED INVERTER TRAINER
SCOPE OF LEARNING:
Speed Control of 3Phase Slip-Ring Induction Motor Using VSI FED Inverter
PEE-587C SINGLE PHASE SHADED POLE MOTOR (SPEED CONTROL)
PEE-587C
PEE-587C SINGLE PHASE SHADED POLE MOTOR (SPEED CONTROL)
SCOPE OF LEARNING:
Speed Control Shaded Motor
PEE-591C SINGLE PHASE CAPACITOR RUN INDUCTION MOTOR (SPEED CONTROL)
PEE-591C
PEE-591C SINGLE PHASE CAPACITOR RUN INDUCTION MOTOR (SPEED CONTROL)
SCOPE OF LEARNING:
Speed Control Capacitor Run AC Ind. Motor
PEE-657B POWER ELECTRONIC TRAINING SYSTEM (TEST BENCH)
PEE-657B
PEE-657B POWER ELECTRONIC TRAINING SYSTEM (TEST BENCH)
SCOPE OF LEARNING:
Single Phase Rectifier and Bridge Converter
Three Phase Rectifier and Bridge Converter
Step Up and Step Down Chopper
Inverter Single Phase Half Bridge and Full Bridge
Temperature PID Controller
DC to DC Generation
DC to AC Generation
Operation on Dynamometer
Three Phase Induction Motor
PEE-704 PROTECTIVE RELAYING TRAINING SYSTEM (GENERATION)
PEE-704
PEE-704 PROTECTIVE RELAYING TRAINING SYSTEM (GENERATION)
SCOPE OF LEARNING:
DC TO AC Generation
Study of 3 Phase Induction Motor
Study of Parallel Operation of Alternator/3Phase Supply
Study of DC Shunt Motor
PEE-704A PROTECTIVE RELAYING TRAINING SYSTEM (TRANSMISSION)
PEE-704A
PEE-704A PROTECTIVE RELAYING TRAINING SYSTEM (TRANSMISSION)
SCOPE OF LEARNING:
Study of RLC Impedance
Study of 3Phase Transmission
Study of 3Phase Distribution
Study of 3Phase Fault Simulation
Study of 3Phase Transformer
Study of 3Phase Half Wave, Full Wave Rectifier
PEE-704B PROTECTIVE RELAYING TRAINING SYSTEM (PROTECTION)
PEE-704B
PEE-704B PROTECTIVE RELAYING TRAINING SYSTEM (PROTECTION)
SCOPE OF LEARNING:
Study about different protection techniques
Current Transformer and Potential Transformer
Voltage Monitoring Relay (Single and Three Phase)
Over Current Relay (Single and Three Phase)
Reverse Power Relay
Phase Sequence Relay
Three Phase Power Factor Relay
Synchro Check Relay
Frequency Monitoring Relay (Three Phase)
PEE-736A SPEED CONTROL OF DC MOTOR USING WARD LEONARD METHOD
PEE-736A
PEE-736A SPEED CONTROL OF DC MOTOR USING WARD LEONARD METHOD
SCOPE OF LEARNING:
Speed Control of DC Motor Using Ward Leonard Method (Exp. On Motor-Generator- Motor)
PEL.101 Tray dryers
PEL.101
Tray dryers are widely used for drying pharmaceuticals, chemicals, powders, granules, plastic granules etc.
Our tray dryer comes with a standard double wall fabrication.
The outer is painted with hammer tone paint finish.
The gap between the walls is fitted with special grade glass wool.
Heavy duty forced air blowers
PEL.102 DRYING OVEN INDUSRTIAL CHAMBER
PEL.102
This is an electrical device which use dry heat to sterilize. It can be operated from ambient to 350 °C, using a thermostat to control the temperature. Their double walled insulation keeps the heat in and conserves energy, the inner layer being a poor conductor and outer layer being metallic.
PEL.103 HOT AIR UNIVERSAL OVEN (MEMMERT TYPE)
PEL.103
This is an electrical device which use dry heat to sterilize. It can be operated from ambient to 250 °C, using a thermostat to control the temperature. Their double walled insulation keeps the heat in and conserves energy, the inner layer being a poor conductor and outer layer being metallic.